리어펜더 연장술

Material: Made of FRP
Specifications: Black gel finish (bare metal), unpainted
Applicable exhaust: Stock/3.5"/4" round muffler,S&S oval/monster oval muffler
Components: Body,Narrow Tail with Turn Signals,Light Reduction Module

**There may be changes in product specifications due to the manufacturer's reasons.
*For FLHX and other touring models not listed above, use DV-1850-RFE8 part number.
Please select the type that comes with the special saddlebag support bracket.
*Bolt on to FLHX/FLTRX.
*Remove the stock rear fender extension and install the Device rear fender extension.
*For touring models other than FLHX/FLTRX, it is necessary to drill 3 holes on each side of the stock rear fender for fixing.
*Use the optional stud plate (DV-0514-STP) for fixing.
*After installation, loosen the muffler mounting bolts and rotate them slightly to adjust the gap between the muffler and the vehicle.
*When you remove the stock tail, there is a hole for the stock tail on the stock rear fender, so please fill it with sheet metal paint.
*It is possible to install genuine and original Device tribar lights.
*Device's original tri-bar lights work in conjunction with the tail lights to illuminate the small and brake lights.
*Wiring modification is required.
*There is no problem under the Road Traffic Law that the brake light shines in conjunction with the brake light.
*If the small light of the triver light is shined, it will be incompatible with the vehicle inspection.
*Wiring modification is required to install tail lamp, tribber light and road equalizer.
*By using the harness kit (sold separately), you can install it by coupler-in without wiring modification.
*Some vehicles require the Road Equalizer III.
*This product is made of FRP.This is an unpainted product with a black gel finish (bare metal).
*Please make sure to check the installation on the vehicle before painting.Check the installation by tightening the bolts and nuts.
*It is recommended to use a professional painter who is knowledgeable about painting.We do not accept returns or exchanges after painting or processing.
*For the convenience of production, a split type mold is used, and burrs may appear on the side of the mold.Please prepare the surface before painting.
*Custom parts are mainly focused on improving the appearance.Please install the product at your own risk with the understanding that it may reduce the original performance of the vehicle.
*In developing and commercializing our products, we have conducted installation and driving tests, but there is a possibility that problems may occur even when the products are installed in vehicles that are considered to be compatible.
*In no event shall any claim be made due to installation.
*Please explain the above characteristics of custom parts to your customers before recommending them to us..