Used to raise the height of the NINJA2 Helmet 50RR (Diversion)
[How is it used?
Used to raise the ride height of the NINJA2 Helmet 50RR.
Traveling:Touring, mountain passes
Period of use:about 6 years
Was the one you received as per Image?
As you can see in the image, it is OEM quality and the mounting holes are accurate.
Was the installation difficult?
In order to remove the rear suspension link, you need to use a jack or a frame stand, so the work is quite difficult.
If you use Jack, you need to find a stable place, remove the side cowl in case you fall over, etc.
How was your experience with it?
The pitch of the mounting hole is shorter than that of the NINJA2 Helmet 50RROEMLink Rod, so it is possible to raise the vehicle height by 5 to 10mm.
Also, since it is slightly lighter than the NINJA2 Helmet 50RROEMLink Rod, it is possible to reduce the weight under the spring, although only to a small extent.
The footing was too good, so we diverted it.
(I found an article on the net about how to lower the NINJA2 Helmet 50RSL using the Link Rod of the NINJA2 Helmet 50RR. I found an article on Net that said "I used the Link Rod of NINJA2 Helmet50RR to lower the NINJA2 Helmet50RSL. So I decided to do it.)
The mounting bolt for the NINJA2 Helmet 50RR can be used without modification.
The current owner continues to use it with no problems.
[Included Parts:were they on?
None
[Was there anything that disappointed you?
None
[Notes]
Use at your own risk.
Jack, Frame Stand, etc. Need to be prepared.
This Custom is for people who have a Skill to maintain the LINK area.
You may be rejected by the Shop.
